Function Setting - Fujitsu ASU9RL Service Instruction

7-1. FUNCTION SETTING

7-1-1 INDOOR UNIT
Follow the instructions in the Local Setup Procedure, which is supplied with the remote control,
in accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
The settings may be selected between the following two: Function Number or Setting Value.
Settings will not be changed if invalid numbers or setting values are selected.
1-1. Setting the Room Temperature Correction for Cooling
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be selected as shown in the table below.
Setting Description
Standard
Lower control
1-2. Setting the Room Temperature Correction for Heating
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be changed as shown in the table below.
Setting Description
Standard
Lower control
Slightly warmer control
Warmer control
1-3. Setting the Auto Restart
The following settings are also possible, depending on the operating conditions.
Setting Description
Yes
No
1-4. Setting the Remoto control Signal Code
The following settings are also possible, depending on the operating conditions.
Setting Description
Code A
Code B
Code C
Code D
( Factory setting)
Function Number Setting Value
30
( Factory setting)
Function Number Setting Value
31
(
Function Number Setting Value
40
(
Function Number Setting Value
44
07-01
00
01
00
01
02
03
Factory setting)
00
01
Factory setting)
00
01
02
03