Detroit Diesel DD15 EuroIV Operator's Manual page 85

NOTE: If a filter service is being performed, replace all other filters before
priming.
1. Install a new prefilter cap seal ring on to the prefilter cap.
2. Snap new prefilter into the prefilter cap.
3. Apply a thin coat of petroleum-based lithium grease to the prefilter cap seal
ring and the prefilter seals (1).
4. Install the prefilter into the fuel filter module.
5. Turn the cap counterclockwise until a click sound is made, then turn
clockwise and hand tighten.
6. Torque prefilter cap to 55-60 N·m (41-44 ft·lb).
7. Once all required filters have been changed, prime the fuel system using the
ESOC 350, J-47912 or the engine mounted hand primer.
WARNING: ENGINE EXHAUST
To avoid injury from inhaling engine exhaust, always operate the
engine in a well-ventilated area. Engine exhaust is toxic.
WARNING: PERSONAL INJURY
To avoid injury before starting and running the engine, ensure the
vehicle is parked on a level surface, parking brake is set, and the
wheels are blocked.
All information subject to change without notice.
DDC-SVC-MAN-0175 Copyright © 2014 DETROIT DIESEL CORPORATION
DD Platform EuroIV Operators Manual
85