Table of Contents
Advertisement
The following guidelines are based on average values and
deviations can and do occur:
•
Position 1 (fully shortened): patient height from about
140 cm and taller.
•
Position 5: patient height from about 170 cm and taller.
•
Position 9 (fully extended): patient height up to about
200 cm.
IMPORTANT
An individual trial fitting is strongly recommended
to determine a correct and safe setting for each
patient.
1
9
A
6
1
9
1. Push and hold the red lever A on the boom upwards.
2. Adjust the length of the lifting arm B to one of the nine
available positions indicated on the scale C, by placing
the desired position field before the edge of the boom.
3. Release the lever A and slightly move the lifting arm B
back and forth until an audible click is heard and it is
locked into position.
5.6 Adjusting the height of the leg
support
1. Push and hold the button A on the leg support B.
2. Slide the leg support B up or down.
3. When the desired height is reached, release the button
A and slightly move the leg support B up or down until
an audible click is heard and the leg support B is locked
into one of the 6 available height positions.
60127405-A
B
C
5
4
3
2
1
5.7 Using the leg band
1.
To apply the leg band, wrap the long padded part
around the leg support and the patient´s lower legs and
push the catch A into the buckle clasp B on the back
side of the leg support.
2.
To open, press the release mechanism C and pull the
catch A out of the buckle clasp B.
3.
To adjust the length of the leg band, either pull on the
lug A to shorten or push the lug A towards the buckle
to lengthen.
When there is no patient in the lift, wrap the leg
band around the leg support, close and shorten it
to tighten.
Usage
15
Advertisement
Table of Contents
