Precautions For Use; Method Of Starting And Finishing - Sony E-mount SEL200600G Service Manual

5-5-2. Precautions for Use

• When the instruction "PUSH ENTER" as shown below is displayed
on the screen, if the "PUSH ENTER" does not disappear even after
pressing the ENTER key, press it again.
• The adjustment result is displayed on the Message area.
Click the [Message Clear] button, the histories displayed on the
Message area will be deleted.
[].[].[].[]
• When the error occurs in the flange back adjustment, the Error-
CodeDisplay screen is appeared.
Please check the contents displayed on the "Possible defect/point
to check" and readjust.
Possible defect/point to check

5-5-3. Method of Starting and Finishing

*
*
Procedure of Starting
1. Set the Shooting Mode of the camera to the P mode (Program
2. Start the ServiceAppLauncher.
[Message Clear]
button
Message area
3. Select "SEL200600G" from the "Select Lens model", and click
4. Click the [Connect] button, and check that the display becomes
Procedure of Finishing
1. Click the [Dis Connect] button and check that the display be-
2. Click the [] button on the upper right of the main window to
3. Turn off the power of camera.
4. Disconnect the AC adaptor.
5-29
Make sure to disconnect the AC adaptor after finishing the adjustment
(including the case when stops due to an error).
SeusEX will start when the SEL200600G_Service_Tool is started.
Auto), then turn the power on.
[].[].[].[]
Note: If the message as shown below is displayed, confi rm that
the following a fi le is stored in "C:\Service\ErrorCodeList"
folder of the C drive.
• ErrorCodeList.xlsx
[OK] to start the SEL200600G_Service_Tool.
[].[].[].[]
"Connection completion!!".
[].[].[].[]
comes "DisConnect".
[].[].[].[]
finish the SEL200600G_Service_Tool.
SEL200600G
SYS SET