Table of Contents
Advertisement
Step 6 Attach Cables,
P10 Floppy
P10 is a 34–pin dual–inline berg. Connect the cable from the floppy
drive to P10, as shown below. The onboard floppy controller cannot be
used if a hard disk card with a floppy controller is installed. Choose
Standard Setup and Peripheral Setup to configure the floppy controller.
The motherboard supports up to two 720 KB, 1.44 MB, or 2.88 MB 3½"
drives and 360 KB and 1.2 MB 5¼" drives. The connecting cable is a
34–pin ribbon connector with two 34–pin edge connectors for attaching
the floppy disk drives. There is a small twist in the cable between the
floppy connectors. The last connector should be connected to floppy
drive A:.
34
MegaPro Dual Pentium Pro PCI ISA Motherboard User's Guide
Continued
Cont'd
Advertisement
Table of Contents
