Bard W3RV2-R Literature Assembly page 40

Security Settings: (continued)
7. Enter button to select Access Levels and enter Access Levels Screen,
scroll through and select among the five (5) Access Levels you would like to secure:
Setpoint Adj., Main Menu, System Mode, Occ Override, and Fan Occ/Unocc
8. Up/Down button(s) to select among the four (4) levels of security for each Access Level
None, User, Operator, and Administrator
9. Enter button to select the new level of security for the Access Level
- Repeat steps 6 through 8 for each of the five (5) Access Levels
9. Left button to navigate back to Security Screen
10. Left button to navigate back to Advanced Screen
11. Left button to navigate back to Main Menu
12. Left button to navigate back to Home Screen
To access/change Passwords from the Home Screen, press:
1. Right button to access Main Menu Screen
2. Down button through entries to highlight Advanced
3. Enter button to select Advanced and enter Advanced Screen
4. Down button through entries to highlight Security
5. Enter button to select Security and enter Security Screen
6. Controller will ask for Admin Level Password
Factory Default Admin Level Password: BARD
7. Down button through entries to highlight Passwords
8. Enter button to select Passwords and enter Passwords Screen
9. Up/Down button(s) to select among the three (3) levels of security passwords
User, Operator, and Administrator ("None" Level has no Password)
10. Enter button to select specific Password
11. Up/Down and Right button(s) to enter digits to specific Passwords
12. Enter button to save Password
- Repeat steps 9 through 12 for each of the three (3) levels of security passwords
13. Left button to navigate back to Security Screen
14. Left button to navigate back to Advanced Screen
15. Left button to navigate back to Main Menu
16. Left button to navigate back to Home Screen
*Note: After any password is given, the only delay to enabling security programming will be the
Inactivity (Secs) setting of controller (60 seconds is factory default). Once 60 seconds of button
inactivity is realized, security settings will go into effect.
**Note: If Admin password is changed to "0000," it will inactivate all security passwords, and allow
unlimited access at all levels.
To access/change Inactivity (Secs) setting of controller from the Home Screen, press:
1. Right button to access Main Menu Screen
2. Down button through entries to highlight System
3. Enter button to select System and enter System Screen
4. Down button through entries to highlight Inactivity (Secs)
5. Enter button to select Inactivity and highlight seconds
6. Up/Down button(s) to adjust amount of seconds of inactivity
7. Enter button to save new time limit
8. Left button to navigate back to Main Menu
9. Left button to navigate back to Home Screen
Manual 2100-560
Page 6 of 8