Table of Contents
Advertisement
IV. OPERATION (continued)
IV. e - DRAWER LOADING
Product should be placed in a way that ensures air can
circulate. Do not operate without the ABS bin in place (see
figure 2).
Fig. 2
V. CARE & MAINTENANCE
DISCONNECT ELECTRICAL POWER SUPPLY
BEFORE CLEANING ANY PARTS OF THE UNIT.
V. a - CLEANING THE EXTERIOR
Exterior stainless steel should be cleaned with warm water,
mild soap and a soft cloth. Apply with a dampened cloth and
wipe in the direction of the metal grain.
Avoid the use of strong detergents and gritty, abrasive
cleaners as they may tend to mar and scratch the surface.
Do NOT use cleaners containing chlorine, this may promote
corrosion of the stainless steel.
V. b - CLEANING THE INTERIOR
For cleaning the interior, the use of baking soda as described
in section V.a is recommended. Use on breaker strips as
well as door and drawer gaskets.
Fig. 3
Bin removal for cleaning
-4-
V. CARE & MAINTENANCE (continued)
V. c - CLEANING THE CONDENSER FAN GUARD
The condenser fan guards are functioning as filter in this
cabinet. Check the fan guard periodically by pulling outward
on the lower louver panel. The operating environment will
affect the required frequency of cleaning. Air must be able
to freely circulate through the condenser. The air intake of
the fan guard must be kept free of dirt and grease for proper
system operation. The condenser fan guard is at the front
of the cabinet, behind the louver panel. Carefully clean dirt
and lint from the condenser fan guard using a vacuum
cleaner or soft brush; do not use a wire brush.
Fig. 4
V. d - CONDENSATE REMOVAL SYSTEM CARE
Condensate removal happens by evaporation at the bottom
of the cabinet with hot gas tube. The unit does not need a
drain. The evaporator coil, condensate loop and condensate
pan can all be flushed with fresh water by a qualified service
technician if needed.
V. e - PREPARING FOR EXTENDED SHUT DOWN
If the refrigerator is not to be used for an extended period of
time, disconnect the electrical power supply and open the
drawers. As soon as the cabinet has warmed up to room
temperature, wipe out the interior. Leave the drawers open
and check again to make sure that no moisture has collected
on any parts. To restart refrigerator, follow instructions under
PRESTART CHECKS and OPERATION.
V. f - ADJUSTING THE DRAWERS
Occasionally the drawer(s) may require alignment
adjustment. To do so, first open the drawer and loosen the
drawer face mounting screws enough to move the drawer
face. Do not completely remove the screws. Next, adjust
and level the drawer face as needed and tighten the screws.
Advertisement
Table of Contents
