Controls From Hubb; Device Menu; Roller Sensitivity Setting Levels; Speaker Led Illumination Colours - Wolf ICON Q2 Instruction Manual

ADJUSTMENT OF BITE ALARM

CONTROLS FROM HUBB

D E V I C E M E N U
When the HUBB has been paired with Alarms press the
corresponding Alarm channel to change any settings. Press
and hold channel button until 'Device Menu' is shown on
screen.
< Device Menu >
[Enter]
When 'Device Menu' is shown, use OK button to enter sub
menu.
Go to 'Sensitivity' to adjust the connected bite Alarm line
sensitivity. Press OK and adjust setting using left or right
arrows. When confirming this option a message will be sent
to the bite Alarm, if successful you will be notified on screen.
R O L L E R S E N S I T I V I T Y S E T T I N G L E V E L S
< Sensitivity >
12 mm
On activation of the bite Alarm the
tone is replicated on the HUBB
and the HUBB LED's replicate the
alert colour shown on the bite
Alarm. Depending on the HUBB's
settings, the HUBB will also vibrate
on alert.
5 Sensitivity Levels.
2mm, 6mm, 18mm, 35mm, or
60mm.
L E D I L L U M I N A T I O N C O L O U R S
< Alert Colour >
Blue
4 Colours: Blue - Yellow - Green - Red - Stealth Mode (Off)
B I T E L E D B R I G H T N E S S
< LED Brightness>
7 3 %
A D V A N C E D M E N U
< Advanced Menu >
[Enter]
Go to 'Alert Colour' to change the
colour used to display alerts on
the bite Alarm and HUBB. Press
OK and adjust setting using left or
right arrows. When confirming this
option a message will be sent to
the bite Alarm, if successful you
will be notified on screen.
Go to 'LED Brightness' to change
the brightness of the LED's
displayed on the bite Alarm. Press
OK and adjust setting using left or
right arrows. When confirming this
option a message will be sent to
the bite Alarm, if successful you
will be notified on screen.
Go back to 'Device Menu', Press
right arrow and go to 'Advanced
Menu' and use OK button to enter
this menu.
8