Control Knobs; Non-Slip Rubber Grip Sensitivity Levels Control; And Rod Protector Dropback Detection; Local Mute - Wolf ICON Q2 Instruction Manual

C O N T R O L K N O B S
The Bite Alarm control knobs can be used to adjust various
settings.
The volume knob adjusts the volume of the alerts
on the Bite Alarm.
The tone knob adjusts the pitch of the alerts on
the Bite Alarm.
S E N S I T I V I T Y L E V E L S C O N T R O L
The Sensitivity Levels of the Q2 can be adjusted by pressing
the menu button.
Press button and release,
1 flash of LED indicates 2mm Sensitivity
Press button again and release,
2 flashes of LED indicates 6mm Sensitivity
Press button again and release,
3 flashes of LED indicates 18mm Sensitivity
Press button again and release,
4 flashes of LED indicates 35mm Sensitivity
Press button again and release,
5 flashes of LED indicates 60mm Sensitivity
D R O P B A C K D E T E C T I O N
During a dropback detection, a two tone signal is triggered
and the LED's should flash.
L O C A L M U T E
The Bite Alarm can be temporarily muted by pressing the
button, The Bite Alarm is muted for 60 seconds.
L O C A L U N - M U T E
The Bite Alarm can be un-muted after it has been muted.
A single press of the
P A I R I N G
When the receiver device is ready for pairing with HUBB
(see receiver device instructions), press and hold the
button until indicator LED turns Blue then release Button,
this will initiate pairing.
F A C T O R Y D E F A U L T
To reset the Bite Alarm to factory settings, and remove all
user data, hold the button while powering on the Bite
Alarm. After the LED's illuminate, release the
A tone will play to confirm the reset.
button will un-mute the Bite Alarm.
button.
5