Inserting Batteries; Battery Level; Rubber Socket Holders - Wolf ICON Q2 Instruction Manual

I N S E R T I N G B A T T E R I E S
Battery
Cover
To insert batteries use a Philips screwdriver and open
2 screws on battery compartment. When inserting new
batteries always replace all of them and turn off Alarm
before replacing. After use of Alarm in damp conditions
leave to dry out somewhere warm before packing away
and if not going to be used for a while it is recommended
to remove batteries in case of leakage. Be careful when
attaching Alarm to banksticks, buzz bars etc. and avoid
over-tightening. See website for full care advice and
instructions.
B A T T E R Y L E V E L
The Battery Level of the
Bite Alarm is displayed
when the button is
pressed..
3 AA 1.5v
Batteries
Good battery level
OK battery level
Bad battery level
P O W E R O N / O F F
R U B B E R S O C K E T H O L D E R S
When IQ Port or Smart LED Port are
not being used the rubber socket
holders should be pressed into ports.
When not needed they should be
pressed into the socket holders on
reverse of Alarm.
To power up the Bite
Alarm, press.the
button until the LED's
turn Blue.
To turn off the Bite
Alarm, press.the
button until the LED's
turn Blue.
NOTE: Hard case will
not shut off Alarm.
4