Specifications; Sensornet; Enhanced Touch Tracker; Declarations - American Dynamics RCTT16BE Installation Manual

Specifications

SensorNet

Bit Rate:............................. 230.4Kbps
Physical Layer: ................. Non-shielded twisted
Link Layer Protocol: .......... SDLC
Application Protocol: ......... Proprietary
Network Nodes: ................ Touch Tracker,

Enhanced Touch Tracker

Operator Inputs: ............... 31-key keypad,
Operator Outputs: ............. LCD screen
Control Input/Output: ........ SensorNet (Domes,
Electrical
Power Source: .................. 16–30Vac at 50/60Hz
Power Consumption: ........ 1400mA, 2A max.
Mechanical, Touch Tracker
Height: .............................. 13cm (5in.)
Width: ............................... 19cm (7.5in.)
Depth: ............................... 26cm (10in.)
Weight: ............................. 1kg (2.2lbs)
Environmental
Operating Temperature: ... 0°–50°C
Relative Humidity: ............ 0%–95%
Storage Temperature: ...... -20°–64°C
Product Compatibility
SensorNet Interface: ........ SpeedDome family
RS-232 Serial Port: .......... Monochrome Mux,
RCTT16BE VM16 PLUS ENHANCED TOUCH TRACKER
INSTALLATION GUIDE
pair
SensorNet Domes
4 micro-switches,
1 Tracker Ball
(2-line x 16 character)
Touch Tracker), RS-232
(multiplexer or quad
splitter)
(32°–122°F)
non-condensing
(-4°–149°F)
Color Mux,
Monochrome Quad,
Color Quad, Intellex,
Standard PC

Declarations

Regulatory Compliance

Emissions:.......................... FCC Part 15 Class A;
Immunity: ........................... EN 50130-4
Safety
FCC COMPLIANCE: This equipment has been tested and found to
comply with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
EQUIPMENT MODIFICATION CAUTION: Equipment changes
or modifications not expressly approved by Sensormatic Electronics
Corporation, the party responsible for FCC compliance, could void the
user's authority to operate the equipment and could create a hazardous
condition.
Other Declarations
INSTALLATION: This installation should be made by a qualified
service person and should conform to all local codes. In North
America, this device is intended to be supplied from a nominal 24Vac
Class 2 power supply. In the EU, this device is intended to be powered
from a Certified (for the country of use), CE marked, source of SELV,
not exceeding 240 VA available.
INSTALLATION: Diese Installation sollte von einem qualifizierten
Wartungstechniker vorgenommen werden und allen örtlichen
Vorschriften entsprechen. In Nordamerika ist dieses Gerät für die
Stromversorgung durch ein Netzgerät der Klasse 2 mit einer
Nennleistung von 24 V Wechselstrom vorgesehen. In der EG ist dieses
Gerät für die Stromversorgung durch eine (für das Verwendungsland)
zertifizierte, mit der CE Marke versehene Schutzkleinspannungsquelle
(SELV) vorgesehen, die 240 V Wechselstrom nicht überschreiten darf.
WARRANTY DISCLAIMER: Sensormatic Electronics Corporation
makes no representation or warranty with respect to the contents
hereof and specifically disclaims any implied warranties of
merchantability or fitness for any particular purpose. Further,
Sensormatic Electronics Corporation reserves the right to revise this
publication and make changes from time to time in the content hereof
without obligation of Sensormatic Electronics Corporation to notify
any person of such revision or changes.
LIMITED RIGHTS NOTICE: For units of the Department of
Defense, all documentation and manuals were developed at private
expense and no part of it was developed using Government Funds.
The restrictions governing the use and disclosure of technical data
marked with this legend are set forth in the definition of "limited
rights" in paragraph (a) (15) of the clause of DFARS 252.227.7013.
Unpublished - rights reserved under the Copyright Laws of the United
States.
TRADEMARK NOTICE: T
Sensormatic logo are trademarks or registered trademarks of
Sensormatic Electronics Corporation. Other product names mentioned
herein may be trademarks or registered trademarks of Sensormatic or
other companies.
No part of this guide may be reproduced in any form without written
permission from Sensormatic Electronics Corporation.
RLJ 5/05
15 of 15
EN 55022 Class B.
Complies with:
UL1950;
CSA - C22.2 No 950-M89;
EN 60950.
T , Sensormatic, and the
OUCH RACKER
8000-2672-01, REV. D1