Sharp XL-1500H Operation Manual page 11

Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM
75 OHMS socket and position the FM
aerial wire in the direction where the
strongest signal can be received.
Supplied AM loop aerial:
Connect the AM loop aerial wire to the
AM and GND terminals. Position the
AM loop aerial for optimum reception.
Place the AM loop aerial on a shelf,
etc., or attach it to a stand or a wall with
screws (not supplied).
Note:
Placing the aerial on the unit or near the AC power lead may cause
noise pickup. Place the aerial away from the unit for better reception.
Installing the AM loop aerial:
< Assembling > < Attaching to the wall >
Wall Screws (not supplied)
External FM or AM aerial:
Use an external FM or AM aerial if you require better reception.
Consult your dealer.
External External AM aerial
FM aerial
15 m (49 feet)
7.5 m (25 feet)
Earth rod
Notes:
When an external FM aerial is used, disconnect the supplied FM
aerial wire from the FM 75 OHMS socket.
When using an external AM aerial, be sure to keep the wire of the
AM loop aerial connected.
Speaker connection
Connect the wire with the white line to the minus (-) terminal and the
black wire to the plus (+) terminal.
Caution:
Connect the speaker wires to the speakers first, then to the
unit.
Use speakers with an impedance of 8 ohms or more, as lower
impedance speakers can damage the unit.
Do not mistake the right and the left channels. The right speaker
is the one on the right side when you face the unit.
Do not let the bare speaker wires touch each other.
Incorrect
Connecting the AC power lead
After checking all the connections have been made correctly, con-
nect the AC power lead to the AC power input socket, then plug the
AM loop aerial
AC power lead of this unit into the wall socket.
Notes:
Unplug the unit if it will not be used for a prolonged period of time.
Never use a power lead other than the one supplied. Otherwise, a
malfunction or an accident may occur.
01/12/3 1500_UK1.fm
XL-1500H
Incorrect
11