Connecting Your Digimux - American Dynamics DigiMux DG4004 Quick Setup Manual

CONNECTING YOUR DIGIMUX

WARNING: POWER SHOULD BE OFF BEFORE MAKING ANY CONNECTIONS
TO THE UNIT.
NOTE: For further details regarding installation and connections, see the
DigiMux User's
1. Video Inputs: Connect the video signal from each camera to one of the
video input BNC connectors marked Video In.
2. Main Monitor Out: Connect the Main Monitor to the Main Monitor
Output of the unit (either BNC or S-VHS connector).
3. Audio In/Out: Connect any amplified audio devices (microphone,
speakers) to the audio I/O ports (optional).
4. Call Monitor Out: Connect the Call Monitor to the Call Monitor Output
BNC connector (optional).
5. External I/O Board: Connect any external alarm devices and dome
cameras to the External I/O board and connect the board to the unit.
6. RJ-11 RS-485 Port: Connect an RS-485 remote keyboard, such as a
ControlCenter 200 or 300 keyboard.
NOTE: The RJ-11 port is not for use with a telephone line.
7. Ethernet Connection: Connect the Ethernet cable for remote network
access.
NOTE: The default IP address must be changed in order to avoid
8. IEEE-1394 HDD Firewire: For expansion with external storage modules.
Quick Setup Guide
Figure 3 — DigiMux Connections
Manual.
conflicts with other units on the network.
3