Parameter Setting Example; Parameter Setting Example On The A/Ans Series - Mitsubishi Electric MELSEC-A Series Manual

6
REPLACEMENT OF CC-LINK

6.8 Parameter Setting Example

The following describes an example how to replace the system in which parameters were set using
sequence program (TO instruction) on the A/AnS series with the system in which parameters are set
using GX Works2 or GX Developer on the Q series.
This section explains the above using the following system configuration example.
Master
station
(X/Y00 to 1F)

6.8.1 Parameter setting example on the A/AnS series

The following shows a program example of parameter setting using the sequence program (TO
instruction).
Module Module
error ready
6
- 25
Station No.4
Station No.1 Station No.2
Remote
Remote (Occupies
device station
I/O station 4 stations)
(Occupies
(Occupies
2 stations)
1 station)
Station No.9
Local
Station No.8
station
Intelligent
Reserved
device station
station
(Occupies
(Occupies
4 stations)
1 station)
Number of automatic return modules
Reserved station specification
Number of stations
5 stations
Number of retries
5 times
2 modules
Number of stations
5 stations
Stop at CPU failure
Stop at
CPU failure
Station No. 8
Reserved station
specification
Station No. 8