Table of Contents
Advertisement
1886
Follow below if you are using the downrod that came pre-assembled in your box. Need to
install a longer or shorter downrod? Check out the guide at the end of this manual.
Hunter Pro Tip:
The ground wire attached to the
downrod is approximately 8 inches.
1
Pass all wires to one side of horizontal
bar in downrod assembly. Hand tighten
the downrod (at least 4–5 full turns)
until it stops. Trim the wires coming
from the fan so that 8-inches remain
coming from the top of the downrod.
Note:
Fan style may vary.
5
Ceiling Bracket
Downrod
Installing the Downrod
2
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN.
WARNING
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS tighten setscrew with pliers.
• DO NOT hand tighten setscrew.
• CHECK the setscrew is tight using pliers
each time you change fan direction.
Hanging the Fan
Hanging Fan
Wiring
NOTICE
To prevent damage to fan,
ALWAYS lift holding either the
fan housing or the downrod.
Place the downrod ball into
the slot in the ceiling bracket.
Canopy
Blades
Upper Switch Housing
Reverse
Advertisement
Table of Contents
