Table of Contents
Advertisement
1. Safety & Environmental Information
General safety instructions
•
Before operating this equipment please read this manual thoroughly and retain it for future reference.
•
Installation and preliminary adjustments should be performed by qualified Barco personnel or by authorized Barco service deal-
ers.
•
All warnings on the projector and in the documentation manuals should be adhered to.
•
All instructions for operating and use of this equipment must be followed precisely.
Notice on safety
This equipment is built in accordance with the requirements of the international safety standards IEC60950-1, EN60950-1,
UL60950-1 and CAN/CSA C22.2 No.60950-1, which are the safety standards of information technology equipment including
electrical business equipment. These safety standards impose important requirements on the use of safety critical components,
materials and insulation, in order to protect the user or operator against risk of electric shock and energy hazard and having access
to live parts. Safety standards also impose limits to the internal and external temperature rises, radiation levels, mechanical stability
and strength, enclosure construction and protection against the risk of fire. Simulated single fault condition testing ensures the
safety of the equipment to the user even when the equipment's normal operation fails.
Owner's record
The part number and serial number are printed on a label which is stuck on the respective part. Record these numbers in the spaces
provided below. Refer to them whenever you call upon your Barco dealer regarding this product.
Product article number
Product serial number
Dealer
1.2
Safety training to be provided by the installer
W
ARNING
that the instructions have been received and understood.
Users definition
The Athena is intended for persons who have been instructed and trained by a skilled person (installer or service personnel) to
identify energy sources that may cause injury and to take precautions to avoid unintentional contact with or exposure to those energy
sources.
The skilled person must instruct the user about:
•
High intensity light beam. The user must respect the exclusion zone, based on the light beam Hazard Distance (HD).
•
Dangerous energy sources inside the projector. The user is not allowed to remove any cover from the projector.
•
Small glass parts can leave the projector in the event of lamp explosion. Keep 1 m (40 in.) distance from the air outlet side of
the projector during operation.
•
The installation, maintenance or service is for skilled persons only.
•
The requirements for a restricted access location and an exclusion zone.
Restricted access location
To protect untrained persons and children, the projector must be installed in a restricted access location. The definition of a
restricted access location is a location for equipment where both of the following paragraphs apply:
•
Access can only be gained by skilled persons (installer or service personnel) or persons who have been instructed and trained
by a skilled person. The persons must have been instructed about the reasons for the restriction applied to the location and
about the precautions that shall be taken.
•
Access is only possible through the use of the tool or lock and key, or other means of security, and is controlled by the authority
responsible for the location.
Exclusion zone
The projector radiates heat on its external surfaces and from ventilation ducts during normal operation. Exposing flammable or
combustible materials into close proximity of this projector could result in the spontaneous ignition of that material, resulting in a
fire. For this reason, it is absolutely necessary to leave an exclusion zone around all external surfaces of the projector whereby no
flammable or combustible materials are present:
2
:
The installer is responsible that the user is instructed. The user will sign a document to confirm
R5906793 ATHENA 26/01/2018
Advertisement
Table of Contents
