Epson FX-880+ Quick Manual page 14

4. Slide the left sprocket approximately 12
mm (0.5 inch) from the far left position
and push the lever back to lock it in
place. Then slide the right sprocket to
match the width of your paper, but do
not lock it. Move the center support
midway between the two sprocket units.
* approx. 12 mm (0.5 inch)
5. Make sure your paper has a clean,
straight edge. Then open the sprocket
covers.
Note:
Make sure the printer is off before you insert
the paper in the paper slot. If you insert the
paper while it is on, a paper jam may occur.
6. Insert the paper into the front or bottom
paper slot as shown in the illustration
below until it emerges between the
platen and the ribbon guide. Then pull
up the paper until the perforation
between the first and second pages is
even with the top of the printer's ribbon.
Downloaded from: http://www.usersmanualguide.com/
EPSON FX-880+/FX-1180+ Quick Guide
Front slot
Before you load paper in the front slot,
remove the front cover.
Then load paper with the printable side
facing up.
Bottom slot
Load paper in the bottom slot with the
printable side facing up.
Continuous Paper with the Pull Tractor (2/4)