Amana AGR5844VD Installation Instructions Manual page 15

30" (76.2 cm) freestanding gas ranges
Hide thumbs Also See for AGR5844VD:
Table of Contents

Advertisement

To Convert Surface Burners
1. Remove burner cap.
2. Using a Phillips screwdriver, remove the burner base.
NOTE: Reinstall one of the screws through the range cooktop
to hold the orifice spud holder in place while removing and
replacing the orifice spuds.
A
B
A. Igniter electrode
B. Gas tube opening
C. Burner cap
D. Burner base
3. Apply masking tape to the end of a
the gas orifice spud in the nut driver while changing it. Press
nut driver down onto the gas orifice spud and remove by
turning it counterclockwise and lifting out. Set gas orifice
spud aside.
A
B
A. Orifice spud
B. Orifice spud holder
C. Screw
D. Spark electrode
4. Remove the cardboard orifice spud holder located on the
back of the range near the gas inlet. Gas orifice spuds are
stamped with a number, marked with 1 color dot, and have a
groove in the hex area. Replace the Natural gas orifice spud
with the correct LP gas orifice spud.
A. LP groove
Refer to the following chart for correct LP gas orifice spud
placement.
C
D
" nut driver to help hold
C
D
A
LP Gas Orifice Spud Chart for Surface Burners
Burner Rating
Color
14,000 BTU
Yellow/Orange
11,000 BTU
Yellow/Brown
8,000 BTU
Yellow/Black
5,000 BTU
Yellow/White
NOTE: Refer to the Model Number and Serial Number Plate
located behind the left side of the storage or warming drawer for
proper sizing of spuds for each burner location.
5. Place Natural gas orifice spuds in the cardboard orifice spud
holder.
6. Replace the burner base using both screw.
7. Replace burner cap.
8. Repeat steps 1-7 for the remaining burners.
To Convert Oven Bake Burner
1. Remove oven racks.
2. Use a ½" combination wrench to turn the orifice hood down
snug onto pin (about 2 to 2½ turns).
IMPORTANT: Do not overtighten.
The oven bake burner flame cannot be properly adjusted if
this conversion is not made. See "Adjust Oven Bake Burner
Flame" in the "Electronic Ignition System" section.
A
Size
ID Number
1.07 mm
L107
0.99 mm
L99
0.85 mm
L85
0.70 mm
L70
B
A
A. Orifice hood
B. Pin
A
15

Advertisement

Table of Contents
loading

Table of Contents