LG OLW480B Installation Manual page 6

3
Fixing the Anchors and Screws in Place
Please follow the instructions below.
- Check the wall material and the thickness of the finish.
- You can use the included anchors and screws only when the wall is made of concrete that will not crack.
- Do not install the device on wood studs, plaster boards, or walls made with medium-density fiberboard (MDF). If installing on such
materials, the anchor screws must be fixed on the concrete behind the finish. If there is no concrete on the other side, then you must
first install a separate hanger to which the anchors and screws can be fixed.
- When installing the product on a type of wall not specified in this manual, make sure each fixed point can withstand a pullout load of
at least 70 kgf (154 lbf, 686 N) and a shear load of at least 100 kgf (220.5 lbf, 980 N).
a
d
- Use an Ø 8 mm drill bit for concrete and a hammer (impact) drill.
a. Drill a hole 80–100 mm(3.15 - 3.94 Inches) deep using an Ø 8 mm drill bit where the anchor will be fixed.
b. Clean out the drilled hole.
c. Insert the provided wall mounting anchor into the hole. (Use a hammer to insert the anchor.)
d. Place the wall mounting bracket against the wall and align it with the holes. Make sure that the tilt adjustment part faces upward.
e. Insert the wall mounting screws into the holes and tighten them. Tighten the screws with a torque between 45 kgf/cm (39 lbf/in)and
60 kgf/cm(52 lbf/in)or more.
6
b
Wall Mounting Screw
e
Wall Mounting Anchor
c