Table of Contents
Advertisement
• The camera boots (~20 seconds). During this time, the display will turn on, off,
and on again. If you press your ear against the enclosure you can hear the
fan.
o If the camera doesn't boot, try holding the button for 10 seconds for a
soft reset. Then press the button again to start the camera.
• After the camera has booted, the Mantis controllers automatically connects to
the camera.
TURNING OFF
• Turn off camera by pressing the mechanical button (right-hand side) all the
way in and hold for 3 seconds.
RECORDING VIDEO
• Ensure the camera is turned on.
• If the camera was turned off, the controller will automatically reconnect. This
can take up to 10 seconds after turning on the camera due to network
timeouts.
• Press the top button firmly to start recording.
• The status LED turns magenta while the Insta360 Pro/Pro2 is preparing to
record.
• The status LED turns off when the Insta360 Pro/Pro2 is recording to not
interfere with the recording.
• Note: The Insta360 Pro2 takes approximately 10 seconds before it starts
recording.
Troubleshooting
• If the camera does not start recording, try pressing the record button
again.
• If the camera still does not start recording and the display remains
unchanged, reboot the camera and try again.
STOP RECORDING VIDEO
• Press lower button firmly to stop recording.
• The status LED turns magenta while the Insta360 Pro/Pro2 is saving.
• The status LED turns green when the Insta360 Pro/Pro2 has saved and is
ready.
• Note: The Insta360 Pro2 takes approximately 7 seconds to stop recording.
CAPTURING TIME-LAPSE PHOTOS
• Attention: The Insta360 Pro/Pro2 needs to be configured for time-lapse photo
mode before entering the water.
All rights reserved. Information and specifications may change at any time without notice.
Version 1.2, 2020-12-02
7
Advertisement
Table of Contents
