Connection And Preparation; Connecting The Antenna And Power Cord; Putting Batteries In The Remote Control - Grundig CINEMO 40 Manual

SAT
1
TV R
Y Pb Pr
ANT. IN
COMPONENT INPUT
AV1
(480i/480p//720p/1080i
OPTICAL AC INPUT

CONNECTION AND PREPARATION

Connecting the antenna and power cord

HDMI1 INPUT HDMI2 INPUT AUDIO INPUT RGB INPUT RS-232C INPUT
(CONTROL/SERVICE)
Plug the roof antenna cable into the »ANT. IN
1
television.
2 Plug the power cord supplied into the power socket »AC INPUT« on the
television.
Plug the power cord into a wall socket.
3
Note:
Do not plug in the power cord of your device until you have connected
the external equipment and the antenna.

Putting batteries in the remote control

Open the battery compartment by removing the lid.
1
Put in the batteries (AA, 2 x 1.5 V).
2
Make sure the polarity is correct (as shown on the base
of the battery compartment).
Close the battery compartment.
3
Note:
If the television no longer reacts properly to remote con-
trol commands, the batteries may be flat. Always remove
used batteries.
The manufacturer accepts no liability for damage caused
by leaking batteries.
Environmental note
Batteries, including those which contain no heavy metal,
should not be disposed of with household waste. Please
dispose of used batteries in an environmentally sound
manner. Find out about the legal regulations which apply
in your area.
2
R L Y Pb Pr
COMPONENT INPUT ANT. IN
AUDIO INPUT (480i/480p//720p/1080i AV1 AV2 AV3 OPTICAL AC INPUT
3
75Ω« socket on the
Ä
_
5