Check Ignition Of Surface Burners - IKEA GRUNDLAGGA 304.620.42 Manual

6. Check burner cap placement.
It is very important to be sure that all surface
burner caps and burner grates are properly installed
and in the correct locations before operating
the appliance. Please note that the burner heads
are secured to the cooktop. The cooktop is not
removeable. Do not attempt to remove or lift the
cooktop.
WARNING!
To prevent flare-ups and avoid creation of harmful
by-products, do not use the cooktop without all
burner caps properly installed to insure proper
ignition and gas flame size.
Always keep the burner caps and burner heads in
place whenever the surface burners are in use. Do
not allow spills, food, cleaning agents or any
other material to enter the gas orifice holder
openings.
Check and be sure the size of each burner cap
matches the size of the burner head. Check and be
sure that all round style burner caps are correctly
in place on round burner heads.
Check and be sure that all oval style burner caps
are correctly in place on oval burner heads (if
equipped). Check and be sure that all dual or twin
style burner caps are correctly in place on dual or
twin burner heads (if equipped).
On round style burners, the burner cap lip (See
Fig. 13) should fit snug into the center of burner
head and be level. Refer to Figs. 14 & 15 for correct
and incorrect burner cap placement.
Once in place, you may check the fit by gently
sliding the burner cap from side to side (Fig. 16) to
be sure it is centered and firmly seated. When the
burner cap lip makes contact inside the center of
the burner head you will be able to hear the burner
cap click. Please note that the burner cap should
NOT move off the center of the burner head when
sliding from side to side.
12
Burner cap
Burner cap lip
Fig. 13
Fig. 16
7. Check ignition of surface
burners.
Operation of electric igniters should be checked
after range and supply line connectors have been
carefully checked for leaks and range has been
connected to electric power.
a. To check for proper ignition, push in and turn
a surface burner knob counterclockwise to the
LITE position. You will hear the igniter sparking.
b. The surface burner should ignite when gas is
available to the burner. Purge air from supply
lines by leaving knob in the LITE position until
burner ignites. Each burner should light within
four (4) seconds in normal operation after air
has been purged from supply lines.
c. Visually check that burner has a flame. Once
the burner ignites, the control knob should be
turned out of the LITE position.
d. Try each surface control knob separately until all
surface burners have been checked. Each burner
location is equipped with a separate electrode.
Correct burner cap placement
Fig. 14
Incorrect burner cap placement
Fig. 15
AA-2195041-2