Basic Connections Diagram - Alpine RUX-C701 Owner's Manual

Installation and Connections
3
Mount the spacer and bracket to the control unit.
Next, securely mount the factory brackets
removed from the factory radio, to the control
unit assembly.
Flat head screws (M5 x 8)
Bracket
Flush Mounting the control unit
1
Make a cut-out approximately 178 (width) by 50
(height) mm (7 inches by 2 inches) in size at
your desired mounting location.
WARNING
When making cut-outs, be careful not to
damage pipes, tanks, electric wires, etc. Doing
so could lead to accidents or fire.
2
After step 2 on "Mounting other units" of
"Mounting the control unit" page 5, remove the
side bracket.
Side bracket
3
Remove the spacer from the bracket.
Spacer
6
-EN
4
5

Basic Connections Diagram

Side bracket
Bracket
Mount the spacer on the control unit using the
included screws.
Spacer
Control unit
Attach the flush mount brackets to the control
unit using the included screws. Mount this
assembly into the prepared cut-out.
Flush mount
Face plate
CAUTION
Do not connect or disconnect the
display cable when the power of the
unit is on.
Display
Display cable
CENTER
SELECTABLE
(L) SUBWOOFER
MIC
(R)
CONTROL UNIT
FRONT 1 FRONT 2 REAR SUBWOOFER OUTPUT INPUT
(FULL RANGE
/TWEETER)
Pan head screw
(M3 x 5) x 2
Self-tapping screw
(M2.6 x 8) x 4
PXA-H701
CD/DVD H.U. CHG DVD
DIGITAL 1 DIGITAL 2 DIGITAL 3
GUIDE (L) (R)
Ai–NET IN CHANGER IN
POWER SUPPLY
ANALOG 1
ANALOG 2 ANALOG 3