Kenwood DMX9720XS Instruction Manual page 57

[Parking Assist Display]
■
When the iDatalink (commercially available)
is connected, you can display information
about obstacles around the car.
[ON]: Always displays information.
[Dyn.] (Default): Displays information when
the sensor detects obstacles.
[OFF]: Cancels this function.
This can be set when the iDatalink
(commercially available) is connected.
[Parking Assist Position]
■
Select where to display information about
obstacles on the screen (left or right).
"Left" (Default)/"Right"
This can be set when the iDatalink
(commercially available) is connected.
[Driving Position]
■
Select the driving position (left or right).
"Left"/"Right" (Default)
Ñ
Learning function of steering
remote
This function is available only when your
vehicle is equipped with the electrical steering
remote controller.
If your steering remote controller is not
compliant, learning may not be completed
and error message may appear.
1
Touch [Steering Remote Controller] in
the User Interface setting menu.
h Steering Remote Controller Setting h
screen appears.
2
Press and hold the steering remote
controller button.
NOTE
• You can have the unit learned all buttons
at a time. In that case, press all buttons one
at a time and after pressing all of them,
touch [Learning completed] in Steering
Remote Controller Setting screen. However,
new functions cannot be learned after this
operation.
3
Touch the function you want to set.
4
Repeat steps 2 and 3 as necessary.
Setup
57
English