Floppy Configuration - Alienware MJ-12 X2 User Manual

S-ATA Ports Definition
The third and fourth IDE Master that are displayed under the IDE configuration screen
represent the two SATA ports SATA1 and SATA2. This setting indicates which SATA is
third and which is fourth.
[Options are: 'P0-3rd./P1-4th.' and 'P0-4th./P1-3rd.']
Configure S-ATA as RAID
Enables or disables RAID on SATA1 and SATA2 through the Adaptec RAID utility.
[Options are: 'Enabled' and 'Disabled']
Primary/Secondary/Third/Fourth IDE Master/Slave
If the device is detected, information on the device is displayed.
Hard Disk Write Protect
Protects the hard drive from being overwritten when it is accessed through BIOS.
[Options are: 'Enabled' and 'Disabled']
IDE Detect Time Out (Sec)
Selects the time out value for detecting ATA/ATAPI devices during boot up.
[Options are: 'Enabled' and 'Disabled']
ATA(PI) 80Pin Cable Detection
Selects the mechanism for detecting 80Pin ATA(PI) cable.
[Options are: 'Host & Device', 'Host', and 'Device']

3.2.3 Floppy Configuration

This screen shows the floppy drives detected and the drive letter assigned to each of
them.
21