Sysex Storage; Realtime Modulation Functions - Alesis Wedge Reference Manual

If the [D] slider is moved to the bottom half of its range so that the value goes below
User 000, the upper display will change to
in the Preset bank.

Sysex Storage

In order to send and receive Program information via Sysex (System Exclusive)
dumps using a computer, or some other Sysex storage device, or another Wedge:
Connect the other device's MIDI OUT to the Wedge's [MIDI IN]. Connect the
Ê
Wedge's [MIDI OUT] to the other device's MIDI IN.
This provides two-way communication between the devices.
Ë Press the [UTIL]button repeatedly until page 5 is selected.
The [UTIL] button will now be flashing, and the display will read:
Send MIDI Sysex: All
Use the [VALUE] knob to select All User Programs, the Edit Buffer, the Program
Ì
Table and the Utility menu settings (
( ), or the Program Change Table (
Buffer
Í Set the receiving MIDI device to receive or record the MIDI information about
to be sent from the Wedge.
Press the flashing [STORE] button to transmit.
Î
The [STORE] button will flash rapidly and the display will read:
Transmitting Sysex...
Ï When you send a Sysex dump back to the Wedge, it will automatically go into
receive mode (you do not have to do anything special). When this occurs, the
display will momentarily read:
RECEIVING MIDI DATA...
Note: If an error occurs while receiving Sysex data back into the Wedge, the display
will briefly indicate:
!!! SYSEX DATA ERROR !!!
If this occurs, try sending the data again. If the problem persists, it may indicate a
bad MIDI cable connection or a problem with the data itself.

Realtime Modulation Functions

You can use various MIDI messages (such as note number, velocity, aftertouch, or
pitch-bend, etc.) to simultaneously control up to two parameters in the Wedge, such
as delay time, room size, etc. Modulation functions are "hard-wired" in each
Configuration, and therefore cannot be changed. However, you can select which
Wedge Reference Manual
MIDI Applications – Chapter 6
indicating you are selecting a Program
Pset
), or the currently selected Program
All
).
Table
67