Wave; Triggered Flange - Alesis Wedge Reference Manual

Chapter 5 – Overview of Effects

Wave

The Wave parameter sets the waveform of the Chorus/Flanger's sweep, either Sine
or Triangle.
SINE TRIANGLE

Triggered Flange

The Flanger effects can be Triggered by the input audio signal. This allows you to
start the flanger at the top of the measure and other rhythmic effects. It starts the
"sweep" of a flanger from the same point whenever it is triggered, and then runs
until the next time you trigger it.
This function is controlled by three parameters:
Trig: This selects which input to monitor to begin triggering. The choices are OFF,
Left, Right, or Left and Right.
Attack: This parameter sets the level where the flange will "trigger" or reset. When
the audio goes above this level, the flanger will begin its sweep.
Release: This is the level where the flanger stops listening to the input. When the
flanger is triggered, it won't trigger again until the input signal falls below the
Release level then goes above the Attack level.
56 Wedge Reference Manual