Connecting To The Channel Inserts Of A Mixing Console - Alesis ModFX Bitrman Reference Manual

Connecting to the Channel Inserts of a
mixing console:
Most recording consoles have a jack near the mic and line inputs
labeled "Insert". This is typically a TRS jack with the send and
return on the same jack. To use the Bitrman as a channel insert,
you will need an insert cable (not included).
Rin g:
I ns er t r etur n
Tip : Sle ev e:
I ns er t s en d I ns er t G ro un d
This cable splits the TRS insert jack into two unbalanced mono
connectors. Usually, the tip is connected to the INPUT of the
Bitrman and the ring is connected to the OUTPUT of the
Bitrman. However, this may be reversed on some recording
consoles. Check your mixer's Reference Manual to be sure or just
try it both ways – this won't damage the Bitrman.
For stereo operation, you would use two insert cables, inserted
into two adjacent channels of the mixer. One would send and
receive signal to the left channel of the Bitrman, and the pan pot
of that mixer channel would normally be panned to the left. Pan
the next mixer channel, for the right side of the Bitrman, to the
right.
I ns er t SEN D:
To Mo dFX I NPU T
I ns er t RETURN :
Fro m Mo d FX O U TPUT
Connections
2
19