Table of Contents
Advertisement
2. F&P ICON MENU SYSTEM
Simple Mode
The Simple Mode is the default Menu System of the F&P ICON.*
* Not in all models
1
2
3
1. On/Off and Ramp
• A quick press to the SmartDial will start therapy.
• To activate Ramp, press the SmartDial again and hold for
3 seconds. The Ramp symbol will appear
2. Humidity
• To control the level of humidity delivered to the mask, turn the
SmartDial to select the desired humidity level from 0 (off ) to 7
(maximum). Press again to accept the change. For example, if the air is
feeling too cold, increase the Humidity setting in increments of 1 or 2
over 2 to 3 nights until you find the level that is comfortable.
NOTE: The default setting is Humidity level 4. If using without water, or
where low power consumption is required (e.g. for aircraft and trucking
use), set the humidity level to 0.
3. Sleep Data
Press and hold the SmartDial for 7 seconds to access the Sleep Data
setting. Turn the SmartDial to scroll through each of the following
statistics:
• Total Compliant Hours
• Average Compliant Hours over the last 30 nights
SmartDial to access the average for the last 7 nights and again for the
last night.
• Percentage of nights used greater than 4 hours over the last 30 nights
. Press the SmartDial to access the percentage for the last
7 nights.
• The number of nights elapsed since therapy commenced .
• Check Sum .
• Exit the Sleep Data setting.
NOTE: A
symbol will appear on the Home Screen once the compliance
requirements have been achieved for the North America models only.
A - 4
.
.
. Press the
Hide quick links:
Advertisement
Table of Contents
