Advertisement
UPDATE YOUR AFRICA TWIN:
Note: Screens shown are representations only, not exact reproductions.
*Please refer to your Bluetooth headset manufacturer for optimal audio settings for use with Android Auto.
1. START INSTALLATION
Turn your bike's ignition switch on. Confirm that the
battery voltage is 12V or more on the MID (display)
screen. Also, make sure the headlight is set to low beam,
and turn off functions like the grip heater, fog lamps, etc.
in order to conserve battery power. Consider connecting
your bike to a battery tender prior to software installation
to maintain battery voltage.
Navigate to the Software Update screen, using the
instructions for "HOW TO LOCATE YOUR SOFTWARE
VERSION". Once on this screen, then connect the USB
drive containing the downloaded file to your motorcycle.
The Africa Twin's USB port is on the fairing, near where
the right front turn blinker stalk attaches to the dash.
The update should automatically start within twenty
seconds after you insert the USB drive.
Do NOT turn the ignition off during the update.
2. CHECKING THE UPDATE STATUS
To check the update status, use the Four-way key/ENT
Switch to navigate from "Setting➔ Service➔ System
Information", then confirm "Software Installation" is
"Installing".
Do NOT turn the ignition off during the update.
3. CONFIRM UPDATE IS COMPLETED
Your dash display should automatically re-start after
update is finished. Disconnect the USB drive after the
usual "speedometer" screen appears on the dash display.
After disconnecting the USB drive, you can check the
update by navigating to "Setting"➔ "Service"➔ "System
information", and then confirming that the "Software
Version" is "3.10".
Advertisement
