Using The Lrc Remote Control - Alesis ADAT Reference Manual

If the transport is currently playing or recording, pressing the
Locate/Play footswitch causes the transport to autolocate to the Locate 1 position
and then either Stop or Play, depending on the Auto Play switch setting.
If ADAT is in the process of locating, pressing the Locate/Play footswitch will stop
the transport.
The footswitch can also be used simultaneously with the LRC remote control if you
observe certain precautions. See the next section.
4.3

USING THE LRC REMOTE CONTROL

To use the LRC, plug it into the Locate/Play/LRC jack. It can control a single ADAT
or the master unit in a chain of ADATs. The LRC offers the following functions:
Transport functions. Rewind, Fast Forward, Stop, Play, Record.
Autolocation functions. Locate 0, Locate 1, Locate 2, Set Locate, Locate 2>1,
and Auto Play.
Track functions. Auto Input and All Input.
Note:
If the Locate/Play footswitch is a normally open type, the footswitch and remote
control can be interchanged at any time, or used simultaneously with a Y-cord. If the
Locate/Play footswitch is a normally closed type, ADAT will have to be reset when
switching between the footswitch and remote, and they will not work simultaneously
with a Y-cord. To do this:
1 Unplug the device you don't want to use (footswitch or remote).
2 Turn off ADAT.
3 Plug in the device you want to use (footswitch or remote).
4 Turn on ADAT.