Table of Contents
Advertisement
64/81
Bosch Rexroth AG
Installation and Maintenance
Wiring the connectors
Connecting the shield
Shield Clip
The desired length (a) depends on the position where you connect the
cores and on whether you intend to place the cores between the connec‐
tion point and shield connection in a generous or a tight arrangement.
●
Shorten the braid to 15 mm ①.
●
Place the braid around the outer sheath ②.
●
Remove the protective foil.
●
Strip the lines for 8 mm ②.
The Rexroth Inline wiring is provided without core end sleeves.
●
Put a screwdriver into the actuation slot of the corresponding terminal point
(figure 8-12, A) so that the core can be inserted into the opening of the
spring.
●
Insert the core (figure 8-12, B). Pull the screwdriver out of the opening.
This fixes the core.
Please refer to the pertinent terminal-specific data sheet for information on the
connector pin assignment .
●
Open the shield connector ③.
●
Check the orientation of the shield clip in the shield connector (see 8-14).
●
Place the line including surrounding braid in the shield connector ④.
●
Close the shield connector ⑤.
●
Tighten the screws on the shield connector using a screwdriver ⑥.
Fig.8-14:
Orientation of the shield clip
The shield clip (a in figure 8-14, ②) in the shield connector can be used ac‐
cording to the line cross-section. If thicker lines are used, the camber of the clip
must be directed away from the line (figure 2 8-14, ②). If thinner lines are used,
the camber of the clip must be directed towards the line (figure 8-14, ⑥).
If you have to change the orientation of the shield clip, proceed as described
below and shown in figure 8-14:
●
Open the housing of the shield connector ①.
DOK-CONTRL-ICL45L65L85-PR01-EN-P
Rexroth IndraControl L45/L65/L85 Control
Hide quick links:
Advertisement
Table of Contents
