Table of Contents
Advertisement
(8) Align the screw holes in the protective plate with those in the bottom of the product, and fi x the protective
plate with three binding head screws.
NOTE: Pay attention to the screw length. The included two screws are a little shorter than the one that
was removed in Step (4).
(9) Be sure that the MCR cable is not caught. Then, fully tighten the two countersunk head screws.
Binding head screws (included)
Binding head screw
Countersunk head screws
Fig. 34
– 15 –
V-R200 Installation Manual
Hide quick links:
Advertisement
Table of Contents
