Getting Started With Basic Techniques
Use the Practice Spray Board to practice these basic spraying techniques before you begin spraying the surface.
•
Hold gun 12 in. (30 cm) from surface and aim
straight at surface. Tilting gun to direct spray angle
causes an uneven finish.
12 in.
(30 cm)
even
finish
•
Flex wrist to keep gun pointed straight. Fanning gun
to direct spray at angle causes uneven finish.
even finish
Triggering Gun
Pull trigger after starting stroke. Release trigger before
end of stroke. Gun must be moving when trigger is
pulled and released.
311984A
thick
uneven
finish
thin
thin
thick
thin
Getting Started With Basic Techniques
Aiming Gun
Aim tip of gun at bottom edge of previous stroke, over-
lapping each stroke by half.
Spray Shield
Use Sample Spray Shield to help shield ceilings and floor
boards from spray. The Sample Spray Shield is intended
to introduce you to the benefits of a spray shield. Visit
your local paint supplier for larger spray shield solutions.
1. Apply a layer of masking tape
approximately 4 inches wide to
edge of spray shield. Change tape
when paint starts to accumulate
on spray shield.
2. Grasp shield firmly through han-
dle grip with one hand.
3. When spraying, use shield
to prevent paint from getting
on ceiling or adjoining walls.
4. Move the spray shield as
you move the gun to protect
surface.
tape
ti9313a
ti9573a
13