Advertisement
17.
Install the switch into the dashboard. Push
in until it snaps into place and then connect
to the proper plug on the wire harness. See
Figure 16.
Figure 16
18.
Use the template (a) on page below and drill
the necessary holes in the flat surface under
the dash for the hand control socket. See
Figure 17.
Additional Attachments & Accessories
Visit cubcadet.com for all available Challenger Utility Vehicle attachments and accessories.
a
Figure 17
Handle Mount Template
19.
Using two #8-32 x .750 machine screws (a),
.194 x .620 x .063 flat washers (b) and #8-32
hex lock nuts (c), mount the hand control
socket (d) onto the dash. See Figure 18.
Behind Dash
c
c
b
a
a
Front of Dash
Figure 18
20.
Tighten all hardware. Secure all wiring away
from any moving parts with the provided
zip ties, bundle any excess wire.
21.
For the rest of the winch wiring instructions,
refer to the provided MotoAlliance winch
Operator's Manual and refer to the Max
Series set-up.
b
d
5
Advertisement
