The new Klipsch sound bars come with specific modes for retail demonstration, display
demonstration, and custom installer mode, in addition to the consumer listening mode (which
is the default out of the box setting).
The retail, display and installer modes have been designed to optimize performance in their
respective environments and access to these modes is not covered in the owner's manual as
they're not for consumer use.
Below is the detail on the settings for each:
How to put the Klipsch sound bar into one of the Demo Modes:
Step 1: Within 10 seconds of plugging in AC power, Press and hold source and volume up
buttons simultaneously for >5 seconds to engage Demo Select mode.
Step 2: While in Demo Select Mode, press the volume + button to cycle through the Consumer,
Display, and Retail modes. Press the Volume + button until the desired mode is flashing. The
following LEDs on the front panel of the sound bar will illuminate to indicate which mode the
sound bar is in:
• HDMI1 LED will fast blink at 4Hz to indicate Consumer Mode.
• Analog LED will fast blink at 4Hz to indicate Display Mode.
• Digital LED will fast blink at 4Hz to indicate Retail Mode.
Sound Bar Demo Mode Instructions