Neutral Adjustment; Neutral Lockout And Tracking Adjustment - Ferris SRS Z1 Series Operator's Manual

Zero-turn riding mower
Hide thumbs Also See for SRS Z1 Series:
Table of Contents

Advertisement

decal for the unit. This figure is intended to help you better
understand the available cutting heights for this unit.
37
 To set the cutting height at 1-3/4" (4,5 cm): 
1. Pull the deck lift lever (A, Figure 38) back towards the
operator position until it locks into the 4-1/2" (11,4 cm)
TRANSPORT position.
38
2. Remove the cutting height adjustment pin (B) from the
hole that it is installed in and put it in the storage location
hole (A, Figure 37). 
3. Pull the deck lift lever back towards the operator position
and depress the deck lift release button (C, Figure 38) to
release the transport position lock. 
4. Push the deck lift lever forward until it contacts the
stationary pin in the 1-3/4" (4,5 cm) hole. 
 To set the cutting height in the range of 2" (5,08 cm) and
4-1/4" (10,8 cm): 
1. Pull the deck lift lever back towards the operator position
until it locks into the 4-1/2" (11,4 cm) TRANSPORT
position. 
2. Place the cutting height adjustment pin in the desired
cutting height hole. 
3. Pull the deck lift lever back towards the operator position
and depress the deck lift release button to release the
transport position lock. 
4. Push the deck lift lever forward until it contacts the cutting
height adjustment pin. 
 To set the cutting height at 4-1/2" (11,4 cm): 
1. Pull the deck lift lever back towards the operator position
until it locks into the 4-1/2" (11,4 cm) TRANSPORT
position. 
2. Place the cutting height adjustment pin in any open hole.
The deck lift lock latch (D) holds the mower deck at the
4-1/2" (11,4 cm) position while cutting. 
Note: Make sure that the cutting height adjustment pin is
inserted into the holes in both upper and lower plates of the
pin box (E). 

Neutral Adjustment

The neutral system for this mower is a function of the
transaxles.
1. Drive the machine to a flat, level surface. Engage the
parking brake and disengage the PTO.
2. Without touching the forward speed control levers
disengage the parking brake. If the unit moves, the
neutral systems on the transaxles are not correctly
adjusted. See your dealer.
Neutral Lockout and Tracking
Adjustment
Before making adjustments to the neutral lockout or the
unit's tracking, be sure to check the following:
• Drive tires are properly inflated.
• Caster tires are greased and turn freely.
• All controls are free from damage and operate freely.
• Machine is at full operating temperature.
• Make sure that the machine is in NEUTRAL when
the ground speed control levers are released per the
procedure detailed in Neutral Adjustment.
Positioning the Parking Brake Handle
1. Park the machine on a flat level surface such as a
concrete floor. Disengage the PTO, engage the parking
29

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Srsz1kav1936Srsz1kav2248Srsz1bv2336Srsz1bv2348Srsz1kav1936 calSrsz1kav2248 cal ... Show all

Table of Contents