Aiphone MYW-MD Instructions

Video Modulator/Demodulator for MY series Video Systems
The MYW-MD adaptor converts the video from a 2-wire signal to a standard coaxial video signal
(Demodulator mode). It can also be used to convert a standard CCTV camera's signal to a 2-wire signal,
compatible with Aiphone's MY series video monitors (Modulator mode).
MODULATOR
MYW-MD to integrate a Standard CCTV camera with an Aiphone Monitor
MY-DC
A1
A2
CCTV Camera
75 Ohm, 1V Peak-to-peak
(Independently powered)
JUMPER CLIP: (Located under rubber cover in upper right corner of the faceplate of the MYW-MD)
Set in Modulator (top) position from factory.
Ensure that jumper clip is
between the top two pins.
MYW-MD
- INSTRUCTIONS -
MYW-MD
MA1
MA2
MV+
Center cond. to MV+
MV-
Braid to MV-
+
-
MYW-MD TERMINAL DEFINITIONS:
MODULATOR:
MA1 2-Wire output to
MA2 MY monitor/adaptor
MV+ Coax input: center cond.
MV- Coax input: Braided shield
+ Positive 18V DC
- Negative
Input signal requirements:
75 ohm, 1V peak-to-peak.
Coax: Solid copper core with copper braid.
MY-2CD*
1A1
1A2
2A1
Polarized
2A2
B1
B2
PS-18C
+
+
-
-
DEMODULATOR:
DA1 2-Wire input from
DA2 MY monitor/adaptor
DV+ Coax output: center cond.
DV- Coax output: Braided shield
+ Positive 18V DC
- Negative
Output signal:
75 ohm, 1V peak-to-peak.
Coax: Solid copper core with copper braid.
Special
Order
Products
*MYW-MD Can also be used with:
MY-1CD
MY-CU
MYW-P1L
MYW-P3L (input only)
Pg. 1