Adjust The Front-Back Position Of The Display Unit (Optional); Mounting The Microphone - Alpine HALO11 Manual

01GB00-US.book Page 4 Monday, April 27, 2020 5:11 PM
Adjust the front-back position of the Display
unit (Optional)
Depending on the vehicle, it may be necessary to adjust the front-
back position of the Display unit when mounting it.
If front-back position adjustment is necessary, set the slider to the
back position before mounting the display unit to the vehicle.
[Default setting: forward position]
WARNING
MAGNETIC SCREWDRIVER REQUIRED TO
CAREFULLY REMOVE SCREWS.
1
Remove 4 flush head screws from the Top and Bottom of
the main unit.
Flush head screw
Flush head screw
2
Push the slider to the back position (To return the slider
to the forward position, pull it forward).
Slider
4
-EN
01GB04-US_EN.fm
3
Tightly fix the slider using the 4 screws that were
removed in Step 1.

Mounting the Microphone

For safe use, make sure of the following:
• Location is stable and firm.
• Does not interfere with safety equipment.
• Driver's view and operations are not obstructed.
• Microphone is located where the driver's voice can be easily
picked up (for example, on the sun visor).
When you speak into the microphone, you should not have to change
your driving posture. This may cause a distraction, taking your
attention away from safely driving your vehicle. Carefully consider
direction and distance while mounting the microphone. Confirm that
Main unit
the driver's voice can be easily picked up at the selected location.
Cable clamp
(sold separately)
Flush head screw
Flush head screw
Microphone
ALPINE iLX-F411/iLX-F409 M3514702010 (EN)