Method To Set Indoor Unit Function Dn Code - Toshiba MMY-MAP1404 Series Quick Reference

27

Method to Set Indoor Unit Function DN Code

When Performing this Task, be sure to Use a Wired Remote Controller
<Procedure> To be performed only when system at rest
1
Push the TEST + SET
4 seconds.
The unit No. displayed first is the address of the header indoor unit in
group control. Then the fan and louver of the selected indoor unit move.
2
Each time the "Select unit" side of the
one of the indoor unit Nos. under group control is displayed in turn.
Then the fan and louver of the selected indoor unit move.
3
Use the button to select the CODE No. (DN code) of the
TEMP.
desired function.
4
Use the button to select the desired SET DATA associated
TIME
with the selected function.
5
Push the SET button. (The display changes from flashing to steady.)
• To change the selected indoor unit, go back to step
• To change the selected function, go back to step
6
When the SET button is pushed, the system returns to normal off state.
Type
DN code "10"
Value
0000 1-way Air Discharge Cassette
0001∗1 4-way Air Discharge Cassette
0002 2-way Air Discharge Cassette
0003 1-way Air Discharge Cassette (Compact)
0004 Concealed Duct Standard
0005 Slim Duct
0006 Concealed Duct High Static Pressure
0007 Under Ceiling
0008 High Wall
0010 Floor Standing Cabinet
0011 Floor Standing Concealed
0013 Floor Standing
0014 Compact 4-way Air Discharge Cassette
0016 Fresh Air Intake indoor unit (Duct type)
0018 Console
0050 DX coil
∗1 Default value stored in EEPROM mounted on service P.C. board
+ CL buttons simultaneously and hold for at least
UNIT LOUVER
Type
button is pressed,
2
.
3
.
Model
MMU-AP SH
∗∗∗
MMU-AP ∗∗∗ H
MMU-AP ∗∗∗ WH
MMU-AP YH
∗∗∗
MMD-AP ∗∗∗ BH
MMD-AP ∗∗∗ SPH (SH)
MMD-AP H
∗∗∗
MMC-AP H
∗∗∗
MMK-AP ∗∗∗ H
MML-AP H
∗∗∗
MML-AP BH
∗∗∗
MMF-AP ∗∗∗ H
MMU-AP ∗∗∗ MH
MMD-AP HFE
∗∗∗
MML-AP ∗∗∗∗ NH-E
MMD-VNK ∗∗∗ HEXE
CODE No.
SET DATA SETTING
UNIT No.
R.C. No.
TEMP. ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
FILTER
RESET TEST SET CL SWING/FIX UNIT LOUVER
5 4
3
1 2
6
Indoor Unit Capacity
DN code "11"
Value Capacity
0000∗1 Invalid
0001 007 type
0003 009 type
0005 012 type
0007 015 type
0009 018 type
0011 024 type
0012 027 type
0013 030 type
0015 036 type
0017 048 type
0018 056 type
0021 072 type
0023 096 type