3Com EtherLink III User Manual page 26

3-8
C
hapter
CAUTION: An ISA adapter configured for an EISA computer
will not work in an ISA computer without being reconfigured.
Refer to the section "Reconfiguring the Adapter for an ISA
Computer" later in this chapter for instructions.
To configure the adapter to work in an EISA computer,
follow steps 1 through 5 in the section "Using the AutoLink
Program" earlier in this chapter.Then follow these steps:
1 When the main menu screen shown in Figure 3-2 appears,
select Configuration/Diagnostic/Troubleshooting and
press [Enter].
2 When the Configuration and Diagnostic screen appears,
select Configuration and Diagnostic Program.
3 Do one of the following:
■ If you have a single adapter installed, the menu selection
Configure Adapter appears already highlighted. Press [Enter],
■ If you have multiple adapters installed, use the arrow keys
to select an adapter and press [Enter],
Test menu bar item highlighted.
a Use the left arrow key to select the Install menu bar item.
The Configure Adapter option will be highlighted.
b Press [Enter].
4 When the Adapter Configuration dialog box appears,
select the <Modify> button. Press [Enter].
The I/O Base Address field is selected, followed by the I/O
Base Address dialog box.
5 Use the arrow key to select EISA. Press [Enter].
This changes the I/O base address setting.
6 Save the new configuration setting to the adapter by
selecting the <OK> button. Press [Enter].
3: C
onfiguring the
A screen identifying the adapter then appears with the
A
dapter