Connect Wiring; Service Parts - NuTone ULTRA SILENT QTXE Series Instructions Manual

CONNECT WIRING

120 VAC
LINE IN
4. Connect electrical wiring.
Run 120 VAC house wiring to installation location.
Use proper UL approved connector to secure house
wiring to wiring plate. Connect wires as shown in
wiring diagrams.

SERVICE PARTS

TAB
SERVICE NOTE
To remove Blower Assembly:
Unplug motor (6).
Remove screw (4) from motor
plate fl ange.
Find the single TAB on the
motor plate (located next to the
receptacle). Push up near motor
plate tab while pushing out on side
of housing. Or insert a straight-blade
screwdriver into slot in housing (next
to tab) and twist screwdriver.
MODELS QTXE080C • QTXE090C • QTXE110C
• QTXEN080C • QTXEN090C • QTXEN110C
INSTALL GRILLE
5. Finish ceiling.
Install ceiling material. Cut out around housing.
6. Attach grille
to housing.
Squeeze grille
s p r i n g s a n d
insert them into
slots on each
side of housing.
7. Push grille
against
ceiling.
No. Part No.
1 97016466 Housing
2 97017187 Duct Connector 6"
3 98010102 Wiring Plate
4 99170245 Screw no. 8-18 x .375" (2 req'd)
5 97016583 Wire Panel/Harness Assembly
10941287
6 10941266
10941267
7 99140200 Grille Spring (2req'd)
97016756 Grille Assembly (includes key no. 7) (QTXE Series)
8
97016460
9 99111293 Spacer (2 supplied)
10 97016909 Hanger Bar Kit
*Assembly not shown
Order service parts by "Part No." - not by "Key No."
REPLACEMENT PARTS AND REPAIRS:
In order to ensure your unit remains in good working condition, you must
use Broan-NuTone genuine replacement parts only. Broan-NuTone genuine
replacement parts are specially designed for each unit and are manufactured
to comply with all the applicable certifi cation standards and maintain a high
standard of safety. Any third party replacement part used may cause serious
damage and drastically reduce the performance level of your unit, which will
result in premature failing. Broan-NuTone also recommends to contact a
Broan-NuTone certifi ed service depot for all replacement parts and repairs.
4
BO0001
BO0018
Description
Blower Assembly QTXE(N)080C*
Blower Assembly QTXE(N)090C
Blower Assembly QTXE(N)110C
Grille Assembly (includes key no. 7)
(for QTXEN Series, not shown)