Initial Operation; Settings On The Device; Placing The Video Matching Resistor - TCS BASIC FBI6119-0400 Product Information

Initial operation

 Install the devices of the system completely
 Proof the a-, b- and P-wire against each other for short-circuits
 V1 and V2 must not be connected with the P-, a- or b-wire
 Observe the polarity when connecting the video wires V1 (+) and V2 (−)
 Switch on the mains voltage
We are continually improving our products. We recommend to visit our homepage regularly and look for
software updates for your device.
Detailed information on our terms of service for TCS IP-enabled systems you'll find at:
http://www.tcsag.de/fileadmin/user_upload/TCS_DE/Metanavigation/Service_Support/Servicebedingun
gen-IP_uk.pdf.

Settings on the device

Placing the video matching resistor

 If the device is installed at the end of a TCS:BUS video
strand, the jumper for the video matching resistor must
be set.
 Ex works the video matching resistor is placed in the
OFF
position
► Pull off the jumper (video matching resistor) from the position
.
► Place the jumper on the position
.
ON
(ill. 8).
OFF
Fig. 7: Placing the matching resistor
11