Hyundai SANTAFE Plug-in hybrid Emergency Response Manual page 23

Roadside Assistance
4. Connect the jumper cables in the exact sequence
shown in the illustration. First connect one jumper
cable to the red, positive (+) jumper terminal of
your vehicle (1).
5. Connect the other end of the jumper cable to the
red, positive (+) battery/jumper terminal of the
assisting vehicle (2).
6. Connect the second jumper cable to the black,
negative (-) battery/chassis ground of the assisting
vehicle (3).
7. Connect the other end of the second jumper
cable to the black, negative (-) chassis ground of
your vehicle (4). Do not allow the jumper cables to
contact anything except the correct battery or
jumper terminals or the correct ground.
8. Start the engine of the assisting vehicle and let it
run about 2000 rpm for a few minutes.
9. Start your vehicle as soon as possible. After
starting vehicle, operate the vehicle safely at least 30
minutes to charge the 12V battery fully. If you do
not run the vehicle enough, the battery may not be
charged enough.
If the cause of your battery discharging is not apparent,
we recommend that the system be checked.
• Do not connect the cables to or near any part that moves when the vehicle is started.
• Do not allow the jumper cables to contact anything except the correct battery terminals or the
correct ground.
• Do not lean over the battery when making connections.
21