Connecting The Power And Communication Cables - Samsung AR Series Technical Data Book

11. Installation
Indoor Unit Installation
2 Use a standard 65 mm hole saw to drill one hole at
the selected location, at a 15° downward angle so
that the drain hose will drain properly.
Indoor unit
3 Based on the hole location, determine where the
piping bundle (drain hose, refrigerant pipes, and
cables) will exit the unit.
Left
NOTE
• The left, right, or bottom exit will only be used if the
hole is not positioned behind the unit.
※ In case you want more information about the controllers and accessories, please refer to the Controller and
Accessory TDB on pvi.Samsung.com site or Global Partner Portal site.
Wall
Drain hose
bottom
<Front view>
Rear right or left
<Side view>

Connecting the power and communication cables

WARNING
• Do not modify the power cable in any way. Doing
so may cause electric shock or fire due to poor
connection, poor insulation, or current limit override.
Make sure to comply with the technical standards of
electrical installations and the wiring regulations in
the local area.
• This appliance must be properly grounded. Do not
ground the appliance to a gas pipe, plastic water
pipe, or telephone line. Failure to comply may result
in electric shock, fire, and explosion.
1 Connect each wire to its corresponding terminal
number.
Model
Power cable
(Outdoor unit)
Right
Outdoor-to-indoor
power cable
Communication
cable
Type GL
Before
connecting
After
connecting
**09*******
**12*******
3G X 2.5 mm²,
H07RN-F
3G X 1.0 mm²,
H07RN-F
2 X 0.75 mm²,
H05RN-F
16A
Upside
Correct Damaged
down
Correct Correct
(Front view) (Side view)
<Circular terminal>
Control box
Non-
circular
Upside
Non-fitted
down