Starting Up; Start-Up Checks; Decommissioning; Disposal - Hussmann Austral H1 Installation Manual

H1 Self Contained glass front multideck
•
Wipe case with a clean, damp cloth, if necessary

Starting up

•
Check supply power is ready and correct voltage. (by Licensed Person)
Turn case power on
Start up checks – by qualified persons only
Check that all fans and lights are working correctly.
Check and set if necessary expansion valves as per Product Engineering Data – Available from Hussmann.
Approximately 24 hours after start-up, check that the case is at correct operating temperature (refer the Product
Engineering Data).

Decommissioning

Plan and risk assess the decommissioning process to include the following:
Isolate the case.
Removal of the case is to be in the reverse order of installation listed previously.

Disposal

Case disposal is to be carried out by the following:
Metal component removed and recycled
Remaining by commercial waste management

Maintenance

General
•
Do not use abrasive, solvent, ammonia or oil based cleaners,
•
Do not use steam or high pressure systems to clean the case as they may reduce the life and alter the
performance of the case
•
The case does not have a floor drain. Do not bucket more than 2 litres into the case during cleaning.
•
Avoid contact between cleaning products and electrical components. Keep electrical connections dry at all times.
•
Wear protective gloves to prevent scratches or cuts
•
Wear safety glasses when there is a risk of splashing from water and cleaning solutions
________________________________________________________________________________________________________________________
Hussmann
Installation manual
Page 8