Ret Return - Samsung S3C9444 User Manual

SAM88RCRI INSTRUCTION SET
RET
— Return
RET
PC ← @SP
Operation:
SP ← SP + 2
The RET instruction is normally used to return to the previously executing procedure at the end of a
procedure entered by a CALL instruction. The contents of the location addressed by the stack
pointer are popped into the program counter. The next statement that is executed is the one that is
addressed by the new program counter value.
Flags: No flags are affected.
Format:
opc
Example: Given: SP = 0BCH, (SP) = 101AH, and PC = 1234:
RET
The statement "RET" pops the contents of stack pointer location 0BCH (10H) into the high byte of
the program counter. The stack pointer then pops the value in location 0BDH (1AH) into the PC's
low byte and the instruction at location 101AH is executed. The stack pointer now points to memory
location 0BEH.
6-38
→
PC = 101AH, SP = 0BEH
S3C9444/F9444_UM_REV1.10
Bytes Cycles
1 8
10
Opcode
(Hex)
AF