Braun UVL 603A Owner's Manual page 8

Lift Operation Safety Precautions (continued)
W ARNING
Load and unload clear of vehicular traffic.
W ARNING
Do not overload or abuse. The load rating applies to both the raising and lowering func-
tions - continuous lifting capacity is 750 lbs.
W ARNING
Do not operate or board the lift if you or your lift operator are intoxicated.
W ARNING
Do not raise front wheelchair wheels (pull wheelie) when loading (boarding) the platform.
W ARNING
Open lift door(s) fully and secure before operating lift.
W ARNING
Position and secure (buckle, engage, fasten, etc.) the wheelchair-equipped occupant seat
belt (torso restraint) before loading onto the wheelchair lift platform.
W ARNING
Fold manual-fold handrails down before stowing lift.
W ARNING
Lift occupant must keep hands, arms and all other body parts within the lift occupant area
and clear of moving parts.
W ARNING
Platform must be positioned at floor level when loading or unloading in and out of vehicle.
W ARNING
Do not use the outboard roll stop as a barrier (brake). Stop and brake wheelchair when
fully loaded on the platform (manually stop and brake manual wheelchairs — stop powered
wheelchairs with the wheelchair controls).
W ARNING
Turn powered (electric) wheelchairs off when on lift platform.
W ARNING
Press the DOWN switch until the entire platform rests on ground level (lowered fully) and
the outboard roll stop is fully unfolded (ramp position) before loading or unloading a pas-
senger at ground level.
W ARNING
Outboard platform roll stop must be fully unfolded (ramp position) before front and rear
wheelchair wheels cross roll stop when loading or unloading at ground level.
W ARNING
Accidental activation of control switch(es) may cause unintended operation(s).
W ARNING
After manually releasing platform, stow platform and push manual release T-handle in fully
and move platform in and out to engage platform lock before driving vehicle. Failure to lock
platform may result in unintended platform deployment.
W ARNING
Insert manual release T-handle fully before manually lowering or raising platform and
manually move platform in and out to engage platform lock.
W ARNING
Maintenance and lubrication procedures must be performed by authorized (certified)
service personnel.
Replace missing, worn or illegible decals.
W ARNING
W ARNING Keep owner's manual in lift vehicle at all times.
Never modify (alter) a Braun Corporation lift.
W ARNING
W ARNING
Do not use accessory devices not authorized by The Braun Corporation.
W ARNING
Do not remove any guards or covers.
Page 6
Lift Operation Safety