ActionTec UP101 User Manual page 19

Actiontec Internet Phone Wizard User Manual
☞
Note: If the Internet Phone Wizard needs to be disconnected from
the computer for any reason, it must be reconnected to the same
port. Connecting the Internet Phone Wizard to a different
USB
port may cause problems.
USB
The Internet Phone Wizard is connected in Single Line mode. Next, go to chapter
4, "Installing the Internet Phone Wizard Software."
Single-Line Connection with Dial-Up Modem
If the computer is connected to the Internet via dial-up modem with no other phone
line in the home, the Internet Phone Wizard can only be set up in Single Line mode.
To connect the Internet Phone Wizard in Single Line mode with a dial-up modem:
1. Get the Internet Phone Wizard from its package.
2. Get the
cable from the package and insert the small, square end of the
USB
cable in the "
USB
3. Insert the other (flat and rectangular) end of the
the front or back of a computer.
4. Get the phone cable from the telephone and insert one end in the "Phone"
port on the rear panel of the Internet Phone Wizard.
5. Connect the other end of the phone cable to the telephone.
6. Optional: To make and receive normal calls while the computer is powered
down, use the supplied phone cable and insert one end of the cable in the "Line"
port on the rear panel of the Internet Phone Wizard.
7. Optional: Insert the other end of the phone cable in the "Phone" port of the dial-
up modem. The components should be connected similarly to the figure below:
" port on the rear panel of the Internet Phone Wizard.
cable in a
USB
16
port on
USB