KTM 1190 RC8 EU 2008 Repair Manual page 75

30/ENGINE
–
Raise the rear of the motorcycle. Position the engine in the frame.
–
Mount screws
–
Secure the motorcycle against falling over with belts.
200530-11
–
Position the swingarm with the shock absorber.
Info
Do not forget the chain.
–
Center the swingarm.
Centering pin (61229051000) (
–
Mount the swingarm pivot. Mount and tighten the nut.
Guideline
200529-01
Nut, swingarm pivot
–
Tighten screws
Guideline
Screw, engine bearer
–
Mount the pin of the bell crank on the frame. Mount and tighten the nut.
Guideline
Nut of bell crank on frame
–
Mount the work stand on the rear.
–
Remove the securing belts.
–
Remove the floor jack with the special tool.
Floor jack attachment (61229055000) (
–
Install the rear brake system. (
200527-10
–
Mount the engine sprocket with the lock washer.
–
Mount and tighten the nut.
Guideline
Nut of engine sprocket
–
Secure the nut with the lock washer.
200528-10
with the washers on both sides but do not tighten them yet.

p. 201)
M19x1.5
.

M10
M14x1.5
p. 57)
M20x1.5
130 Nm Thread greased
(95.9 lbf ft)
45 Nm
(33.2 lbf ft)
100 Nm
(73.8 lbf ft)
p. 201)
100 Nm Loctite ® 243™
(73.8 lbf ft)
73